Nissan Rogue Service Manual: Anti-pinch function does not operate

Nissan Rogue Service Manual / Body exterior, doors, roof & vehicle security / Roof / Symptom diagnosis / Anti-pinch function does not operate

MOONROOF

MOONROOF : Diagnosis Procedure

1. PERFORM INITIALIZATION PROCEDURE

Perform initialization procedure.

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 2.

NO >> Perform basic inspection. Refer to RF-22, "Work Flow".

2.RETEST THE ANTI-PINCH FUNCTION

Check anti-pinch operation. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Replace the moonroof motor assembly. Refer to RF-53, "Removal and Installation".

SUNSHADE

SUNSHADE : Diagnosis Procedure

1.CHECK SUNSHADE MECHANISM

Check the following:

Operation malfunction caused by sunshade mechanism deformation, pinched harness or other foreign materials
Operation malfunction and interference with other parts by poor installation

Is the inspection result normal? YES >> GO TO 2.

NO >> Repair or replace the malfunctioning parts.

2. PERFORM INITILAZATION PROCEDURE

Perform anti-pinch procedure.

Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> GO TO 3.

NO >> GO TO 1.

3.RETEST THE ANTI-PINCH FUNCTION

Check anti-pinch operation. Refer toRF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement".

Is the inspection result normal? YES >> Inspection End.

NO >> Replace the sunshade motor assembly. Refer to RF-62, "Removal and Installation".

Auto operation does not operate

MOONROOF MOONROOF : Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to RF-24, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repai ...

Retained power operation does not operate properly

Diagnosis Procedure 1.CHECK FRONT DOOR SWITCH Check (LH and RH) front door switches. Refer to DLK-24, "Front Door Switch". Is the inspection result normal? YES >> GO TO 2. ...

Other materials:

ABC warning lamp
Component Function Check 1.CHECK ABS WARNING LAMP FUNCTION Check that ABS warning lamp in combination meter turns ON for 1 second after ignition switch is turned ON. CAUTION: Never start the engine. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to BRC-1 ...

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

B0020 side airbag module IH
Description DTC B0020 FRONT LH SIDE AIR BAG MODULE The front LH side air bag module is wired to the air bag diagnosis sensor unit. The air bag diagnosis sensor unit will monitor for opens and shorts in detected lines to the front LH side air bag module. PART LOCATION Refer to SRC-6, "C ...