Nissan Rogue Service Manual: C1769 configuration setting

Nissan Rogue Service Manual / Suspension / Road Wheels & Tires / DTC/circuit diagnosis / C1769 configuration setting

DTC Description

This procedure must be performed:

After replacement of BCM.

DTC DETECTION LOGIC

DTC	Display Item	Malfunction detected condition
C1769	CONFIG SETTING (Configuration setting)	Tire air pressure monitoring system configuration cannot be performed.
C1769	CONFIG SETTING (Configuration setting)	Receiver ID registration cannot be performed.

Diagnosis Procedure

1.TIRE PRESSURE MONITORING SYSTEM CONFIGURATION

Perform configuration.

>> Refer to WT-21, "Work Procedure", and GO TO 2.

2.TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".

Does low tire pressure warning lamp turn OFF? YES >> Inspection End.

NO >> Configuration setting tire pressure monitoring system. Refer to WT-21, "Work Procedure".

C1765, C1766, C1767, C1768 tire pressure sensor

DTC Description DTC DETECTION LOGIC DTC Display Item Malfunction Detected Condition Possible Cause C1765 WHEEL TOP DATA FL (Wheel top data front left) Malfunction i ...

C1770, C1771, C1772, C1773 G sensor

DTC Description DTC DETECTION LOGIC DTC Display Item Malfunction Detected Condition Possible Causes C1770 G SENSOR FL (G sensor front left) Malfunction in the G sen ...

Other materials:

P0456 EVAP control system
DTC Description DTC DETECTION LOGIC This diagnosis detects leaks in the EVAP line between fuel tank and EVAP canister purge volume control solenoid valve, using the negative pressure caused by decrease of fuel temperature in the fuel tank after turning ignition switch OFF. If ECM judges t ...

How to follow trouble diagnoses
Description NOTICE: Trouble diagnoses indicate work procedures required to diagnose problems effectively. Observe the following instructions before diagnosing. Before performing trouble diagnoses, read the “Work Flow” in each section. After repairs, re-check that the pr ...

C1198 vacuum sensor
DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1198 VACUUM SEN CIR When an open circuit is detected in vacuum sensor circuit. When a short circuit is detected in vacuum sensor circuit. &nb ...