Hill start assist system
WARNING
|
When the vehicle is stopped on a hill, the hill start assist system automatically keeps the brakes applied.
This helps prevent the vehicle from rolling backward in the time it takes the driver to release the brake pedal and apply the accelerator.
Hill start assist will operate automatically under the following conditions:
The maximum holding time is two seconds. After two seconds the vehicle will begin to roll back and hill start assist will stop operating completely.
Hill start assist will not operate when the shift lever is shifted into N (Neutral) or P (Park) or on a flat and level road.
C1609 vehicle speed signal
DTC Logic
DTC DETECTION LOGIC
DTC
Display item
Malfunction detected condition
Possible cause
C1609
CAN VHCL SPEED
Malfunction is detected in vehicle speed signal that
is output from ABS actuator and electric unit (control
unit) via CA ...
System description
DESCRIPTION
Engine Cooling System
Thermostat
Water outlet
Cylinder block (Thermostat housing)
Water inlet
Radiator
Water pump
Cylinder block
Cylinder head
Open
Closed
To electric throttle control actuator
To oil cooler
...
System description
COMPONENT PARTS
BODY CONTROL SYSTEM
BODY CONTROL SYSTEM : Component Parts Location
BCM
Behind instrument panel (LH)
POWER CONSUMPTION CONTROL SYSTEM
POWER CONSUMPTION CONTROL SYSTEM : Component Parts Location
Combination meter
Refer to MWI-6, "METER SYSTEM :
Componen ...