Nissan Rogue Service Manual: Inspection and adjustment

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Description

If any of the following work has been done Initial setting is necessary.

•  Power supply to the main power window and door lock/unlock switch or power window motor is cut off by the removal of battery terminal or the battery fuse is blown.
•  Disconnection and connection of main power window and door lock/unlock switch harness connector.
•  Removal and installation of motor from regulator assembly.
•  Operation of regulator assembly as an independent unit.
•  Removal and installation of glass.
•  Removal and installation of door glass run.

  The following specified operations can not be performed under the non-initialized condition.

•  Auto-up operation
•  Anti-pinch function

ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement

INITIALIZATION PROCEDURE

1.  Disconnect battery minus terminal or main power and window door lock/unlock switch connector. Reconnect it after a minute or more.
2.  Turn ignition switch ON.
3.  Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open)
4. Continue pulling the power window switch UP (AUTO-UP operation). Even after glass stops at fully closed position, keep pulling the switch for 2 seconds or more.
5.  Initializing procedure is completely.
6.  Inspect anti-pinch function.

CHECK ANTI-PINCH FUNCTION

1.  Fully open the door window.
2.  Place a piece of wood near fully closed position.
3.  Close door glass completely with AUTO-UP.

•  Check that glass lowers for approximately 150 mm (5.9 in) without pinching piece of wood and stops.
•  Check that glass does not rise when operating the main power and door lock/unlock switch while lowering.

CAUTION:

•  Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
•  Check that AUTO-UP operates before inspection when system initialization is performed.
•  Do not check with hands and other body parts because they may be pinched. Do not get pinched.
•  It may switch to fail-safe mode if open/close operation is performed continuously without full close.

  Perform initial setting in that situation. Refer to BCS-47, "Fail Safe"

•  Finish initial setting. Otherwise, next operation cannot be done.

1.  Auto-up operation
2.  Anti-pinch function

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Description

Refer to PWC-27, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Description".

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement

Refer to PWC-27, "ADDITIONAL SERVICE WHEN REMOVING BATTERY NEGATIVE TERMINAL : Special Repair Requirement" for initialization procedure and check anti-pinch function.