Nissan Rogue Service Manual: The oil pressure warning continues displaying, or does not display
Description
- The low oil pressure warning message stays on when oil pressure is normal.
- The low oil pressure warning message stays off when oil pressure is low.
Diagnosis Procedure
1.CHECK COMBINATION METER INPUT
- Start the engine and select “METER/M&A” on CONSULT.
- Observe “OIL W/L” in “Data Monitor” and the operation of the low oil pressure warning message in the information display.
Is the inspection result normal? YES >> Perform “Self Diagnosis” of “ECM”. Refer to EC-67, "CONSULT Function".
NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
The fuel gauge does not move
Description
Fuel gauge does not move from a certain position.
Diagnosis Procedure
1.CONDUCTING THE COMBINATION METER SELF-DIAGNOSIS MODE
Perform the self-diagnosis mode of combination meter, and t ...
The parking brake release warning continues displaying,
or does not display
Description
The parking brake warning is displayed during vehicle travel even though
the parking brake is released.
The parking brake warning is not displayed even though driving the
...
Other materials:
P0743 torque converter
DTC Description
DTC DETECTION LOGIC
DTC
CONSULT screen terms
(Trouble diagnosis content)
DTC detection condition
P0743
TORQUE CONVERTER
(Torque Converter Clutch Circuit Electrical)
When all of the following conditions are satisfied and this state is
maintained ...
P0181 FTT sensor
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0181
FTT SENSOR
(Fuel temperature sensor ″A″ circuit range/
performance)
A
Rationally incorrect voltage from the sensor is sent ...
Windshield wiper blades
Cleaning
If your windshield is not clear after using the
windshield-washer or if a wiper blade chatters
when running, wax or other material may be on
the blade or windshield.
Clean the outside of the windshield with a washer
solution or a mild detergent. Your windshield is
clean if beads d ...