DTC Logic
DTC DETECTION LOGIC
| DTC | Display Item | Malfunction detected condition | Possible causes |
| C1130 | ENGINE SIGNAL 1 | When a malfunction is detected in ECM system. |
|
DTC CONFIRMATION PROCEDURE
1.CHECK SELF-DIAGNOSTIC RESULT
With CONSULT.
Is DTC C1130 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-91, "Diagnosis Procedure".
NO >> Inspection End.
Diagnosis Procedure
1.CHECK SELF-DIAGNOSTIC RESULT FOR ENGINE SYSTEM
With CONSULT.
Perform self-diagnostic result. Refer to EC-67, "CONSULT Function".
Are any ECM DTCs detected? YES >> Refer to EC-93, "DTC Index".
NO >> GO TO 2.
2.CHECK SELF-DIAGNOSTIC RESULT FOR ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)
With CONSULT.
Is DTC C1130 detected? YES >> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".
NO >> Check pin terminals and connection of connectors for abnormal conditions. Repair or replace malfunctioning components.
C1121, C1123, C1125, C1127 ABS out valve system
C1140 actuator relay systemiPod®* player operation without Navigation System (if so equipped)
iPod®* player operation without Navigation System
Connecting iPod
WARNINGDo not connect, disconnect, or operate the
USB device while driving. Doing so can be
a distraction. If distracted you could lose
control of your vehicle and cause an accident
or serious injury.
& ...
NISSAN Jackknife key (if so equipped)
Replace the battery in the jackknife key as follows:
Hold jackknife key button side up. Insert a
small screwdriver into the slit of the corner
and twist it to separate the upper part from
the lower part. Use a cloth to protect the
casing.
Remove old battery.
Replace t ...
P052A, P052B intake valve timing control
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P052A
CAMSHAFT POSITION TIMING B1
(Cold start “A� camshaft position timing
over-advanced bank 1)
There is a gap between angle of target and ...