Nissan Rogue Owners Manual: Door locks/unlocks precaution

Nissan Rogue Owners Manual / Pre-driving checks and adjustments / NISSAN Intelligent Key® (if so equipped) / Door locks/unlocks precaution

Door locks/unlocks precaution

Do not push the door handle request switch with the Intelligent Key held in your hand as illustrated. The close distance to the door handle will cause the Intelligent Key system to have difficulty recognizing that the Intelligent Key is outside the vehicle.
After locking with the door handle request switch, verify the doors are securely locked by testing them.
To prevent the Intelligent Key from being left inside the vehicle, make sure you carry the Intelligent Key with you and then lock the doors.
Do not pull the door handle before pushing the door handle request switch. The door will be unlocked but will not open. Release the door handle once and pull it again to open the door.

Operating range

Operating range The Intelligent Key functions can only be used when the Intelligent Key is within the specified operating range from the request switch 1 . When the Intelligent Key battery i ...

NISSAN Intelligent Key® Operation

NISSAN Intelligent Key® Operation You can lock or unlock the doors without taking the Intelligent Key out of your pocket or bag. When you carry the Intelligent Key with you, you can lock or ...

Other materials:

P0078 EVT control solenoid valve
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condit P0078 EX V/T ACT/CIRC-B1 (Exhaust valve control solenoid circuit bank 1) An improper voltage is sent to the ECM through exhaust valve timing co ...

Additional service when replacing TCM
Description Always perform the following items when the TCM is replaced. TCM PROGRAMMING Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT. CAUTION: When replacing TCM, save TCM data on CONSULT before removing TCM. SAVING ...

Hood
Hood Pull the hood lock release handle 1 located below the instrument panel until the hood springs up slightly. Locate the lever 2 in between the hood and grille and push the lever sideways with your fingertips. Raise the hood 3 . Remove the support rod 4 and in ...