Nissan Rogue Service Manual: Additional service when replacing TCM

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Basic inspection / Additional service when replacing TCM

Description

Always perform the following items when the TCM is replaced.

TCM PROGRAMMING

Since vehicle specifications are not yet written in a new TCM, it is necessary to write them with CONSULT.

CAUTION: When replacing TCM, save TCM data on CONSULT before removing TCM.

SAVING AND WRITING OF TCM DATA

TCM performs accurate control by retrieving data (inherent characteristic value) of each solenoid. For this reason, it is necessary to save data of current TCM in CONSULT before replacing the TCM. After this, the saved data must be written in new TCM.

Work Procedure

1.SAVE TCM DATA (IP CHARACTERISTICS VALUE)

NOTE: Save necessary data stored in TCM in CONSULT according to the following instructions:

With CONSULT

Turn ignition switch OFF and wait for 10 seconds.
Turn ignition switch ON.
Select “Work Support” in “TRANSMISSION”.
Select “READ IP CHARA - REPLACEMENT TCM”.
Import data according to the instructions on the CONSULT screen.

>> GO TO 2.

2.SAVE TCM DATA (VEHICLE SPECIFICATIONS)

With CONSULT

Turn ignition switch OFF.
Turn ignition switch ON.
Select “Re/programming, Configuration”.
Select “AT/CVT”.

NOTE: If “AT/CVT” is not displayed and TCM data cannot be saved on CONSULT, GO TO 3.

Select “Programming”.
Save TCM data on CONSULT according to the CONSULT display.

>> GO TO 3.

3.REPLACE TCM

Turn ignition switch OFF and wait for 10 seconds.
Replace TCM. Refer to TM-202, "Removal and Installation".

>> GO TO 4.

4.WRITE TCM DATA (VEHICLE SPECIFICATIONS)

With CONSULT

Select “Programming”.
Perform programming according to the CONSULT display.

>> GO TO 5.

5.WRITE TCM DATA (IP CHARACTERISTICS VALUE)

NOTE: Write data saved in CONSULT into a new TCM according to the following instructions:

With CONSULT

Turn ignition switch OFF and wait for 10 seconds.
Turn ignition switch ON.
Select “Work Support” in “TRANSMISSION”.
elect “WRITE IP CHARA - REPLACEMENT TCM”.
Write data saved in CONSULT in TCM according to the instructions on the CONSULT screen.

>> WORK END

Diagnosis and repair work flow

Work Flow NOTE: “DTC” includes DTC at the 1st trip. 1.OBTAIN INFORMATION ABOUT SYMPTOM Refer to TM-80, "Diagnostic Work Sheet" and interview the customer to obtain the malfunction ...

Additional service when replacing transaxle assembly

Description Perform the following work after the transaxle assembly is replaced. WRITING TCM DATA TCM performs accurate control by retrieving data (inherent characteristic value) of eac ...

Other materials:

ECU diagnosis information
A/C AUTO AMP. Reference Value VALUES ON THE DIAGNOSIS TOOL TERMINAL LAYOUT PHYSICAL VALUES DTC Inspection Priority Chart If some DTCs are displayed at the same time, perform inspections one by one based on the following priority chart. Priority Det ...

Rear regulator
Exploded View Rear door panel Rear door glass corner finisher Rear door glass rear run channel Rear door regulator assembly Rear door glass power window motor Rear door glass Rear door glass rubber run channel Removal and Installation REMOVAL Remove the re ...

Combination meter
Reference Value VALUES ON THE DIAGNOSIS TOOL *: DDS (hill descent control) NOTE: Some items are not available according to vehicle specification. TERMINAL LAYOUT PHYSICAL VALUES Fail-safe The combination meter activates the fail-safe control if the CAN communica ...