Nissan Rogue Service Manual: C1113, C1145, C1146 yaw rate/side/decel G sensor

Nissan Rogue Service Manual / Brakes / Brake Control System / DTC/circuit diagnosis / C1113, C1145, C1146 yaw rate/side/decel G sensor

DTC	Display Item	Malfunction detected condition	Possible causes
C1113	G SENSOR	When a malfunction is detected in longitudinal G sensor signal.	Harness or connector Yaw rate/side/decel G sensor • ABS actuator and electric unit (control unit) Ignition power supply system Fuse
C1145	YAW RATE SENSOR	When a malfunction is detected in yaw rate signal. When yaw rate signal is not continuously received for 2 seconds or more. When side G signal is not continuously received for 2 seconds or more. When decel G signal is not continuously received for 2 seconds or more.
C1146	SIDE G-SEN CIRCUIT	When a malfunction is detected in side/decel G signal.

DTC CONFIRMATION PROCEDURE

1.CHECK SELF DIAGNOSTIC RESULT

With CONSULT.

Turn ignition switch OFF to ON.
Perform self diagnostic result.

Is DTC C1113, C1145 or C1146 detected? YES >> Proceed to diagnosis procedure. Refer to BRC-84, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

1.REPLACE ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)

Replace ABS actuator and electric unit (control unit).

>> Replace ABS actuator and electric unit (control unit). Refer to BRC-136, "Removal and Installation".

C1111 pump motor

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1111 PUMP MOTOR When a malfunction is detected in motor or motor relay. ...

C1115 ABS sensor [abnormal signal]

DTC Logic DTC DETECTION LOGIC DTC Display Item Malfunction detected condition Possible causes C1115 ABS SENSOR [ABNORMAL SIGNAL] When difference in wheel speed betw ...

Other materials:

Removal and installation
FRONT COMBINATION LAMP Exploded View Front fender Front combination lamp Clip Removal and Installation REMOVAL Remove front bumper fascia. Refer to EXT-17, "Removal and Installation". Remove front combination lamp bolts and clip. Pull front c ...

Power window and door lock/unlock switch RH
Removal and Installation REMOVAL Remove the front door pull handle bracket (RH). Refer to INT-15, "Removal and Installation". Release pawls using a suitable tool (A) and remove front door power window and door lock/unlock switch finisher (RH) (1). : Pawl D ...

B0029 side curtain air bag module RH
DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order CURTAIN AIRBAG MODULE RH CIRCUIT [OPEN] B0029 RH side curtain air bag module circuit is open. Refer to SRC-57, "Diagnosis Procedure". CURTA ...