Nissan Rogue Service Manual: C1716, C1717, C1718, C1719 transmitter (pressure data)

DTC Logic

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

•  Activate and display TPMS sensor IDs
•  Display tire pressure reported by the TPMS sensor
•  Read TPMS DTCs
•  Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1.  Check tire pressure for all wheels and adjust to the specified value. Refer to WT-65, "Tire Air Pressure".
2.  Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
3.  Perform Self Diagnostic Result.

Is DTC C1716, C1717, C1718, or C1719 detected? YES >> Proceed to WT-29, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

•  Activate and display TPMS sensor IDs
•  Display tire pressure reported by the TPMS sensor
•  Read TPMS DTCs
•  Register TPMS sensor IDs

1.TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".

Can the tire pressure sensor ID registration be completed? YES >> GO TO 2.

NO >> Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".

2.CHECK TIRE PRESSURE SIGNAL

With CONSULT

1.  Adjust tire pressure for all wheels to the specified value. Refer to WT-65, "Tire Air Pressure".
2.  Select “AIR PRESSURE MONITOR” from “BCM”.
3.  Check that the air pressures match the specified value.

Is the inspection result normal? YES >> Inspection End.

NO >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS- 135, "Removal and Installation" (without Intelligent Key System).