Nissan Rogue Service Manual: C1729 vehicle speed signal

Nissan Rogue Service Manual / Suspension / Road Wheels & Tires / DTC/circuit diagnosis / C1729 vehicle speed signal

DTC Logic

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC	Display Item	Malfunction Detected Condition	Possible Cause
C1729	VHCL SPEED SIG ERR	Vehicle speed signal not detected	CAN communication BCM Combination meter

DTC CONFIRMATION PROCEDURE

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT.

Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
Perform Self Diagnostic Result.

Is DTC C1729 detected? YES >> Proceed to WT-31, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

Activate and display TPMS sensor IDs
Display tire pressure reported by the TPMS sensor
Read TPMS DTCs
Register TPMS sensor IDs

1.PERFORM SELF DIAGNOSTIC RESULT FOR COMBINATION METER

With CONSULT

Perform Self Diagnostic Result for METER M&A. Refer to MWI-21, "CONSULT Function (METER/M&A)".

Are any DTCs detected? YES >> Refer to BCS-48, "DTC Index" (with Intelligent Key System) or BCS-108, "DTC Index" (without Intelligent Key System).

NO >> Replace the BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key System) or BCS-135, "Removal and Installation" (without Intelligent Key System).

C1716, C1717, C1718, C1719 transmitter (pressure data)

DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and dis ...

C1730, C1731, C1732, C1733 flat tire

DTC Logic NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information. Activate and dis ...

Other materials:

Precaution
Precaution for Supplemental Restraint System (SRS) "AIR BAG" and "SEAT BELT PRE-TENSIONER" The Supplemental Restraint System such as “AIR BAG” and “SEAT BELT PRE-TENSIONER”, used along with a front seat belt, helps to reduce the risk or severity of injury to the ...

Symptom diagnosis
ENGINE DOES NOT START WHEN INTELLIGENT KEY IS INSIDE OF VEHICLE Description Engine does not start when push-button ignition switch is pressed while carrying Intelligent Key. NOTE: Check that vehicle is under the condition shown in “Conditions of vehicle” before starting diagnos ...

Removal and installation
ACCELERATOR PEDAL ASSEMBLY Exploded View Brake pedal Accelerator pedal assembly Locator hook Locator pin Bolt Removal and Installation REMOVAL Disconnect the harness connector from the accelerator pedal assembly. Remove the bolts, then rem ...