Nissan Rogue Service Manual: C1730, C1731, C1732, C1733 flat tire

DTC Logic

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

•  Activate and display TPMS sensor IDs
•  Display tire pressure reported by the TPMS sensor
•  Read TPMS DTCs
•  Register TPMS sensor IDs

DTC DETECTION LOGIC

DTC CONFIRMATION PROCEDURE

1.PERFORM SELF DIAGNOSTIC RESULT

With CONSULT

1.  Drive at a speed of 40 km/h (25 MPH) or more for 3 minutes, and then drive the vehicle at any speed for 10 minutes.
2.  Perform Self Diagnostic Result.

Is DTC C1730, C1731, C1732, or C1733 detected? YES >> Proceed to WT-32, "Diagnosis Procedure".

NO >> Inspection End.

Diagnosis Procedure

NOTE: The Signal Tech II Tool [- (J-50190)] can be used to perform the following functions. Refer to the Signal Tech II User Guide for additional information.

•  Activate and display TPMS sensor IDs
•  Display tire pressure reported by the TPMS sensor
•  Read TPMS DTCs
•  Register TPMS sensor IDs

1.TIRE PRESSURE SENSOR ID REGISTRATION

Perform tire pressure sensor ID registration. Refer to WT-21, "Work Procedure".

Can the tire pressure sensor ID registration be completed? YES >> GO TO 2.

NO >> Replace applicable tire pressure sensor. Refer to WT-61, "Removal and Installation".

2.CHECK TIRE PRESSURE

Check the air pressure of all wheels. Refer to WT-65, "Tire Air Pressure".

Is the inspection result normal? YES >> Perform DTC CONFIRMATION PROCEDURE again. Refer to WT-32, "DTC Logic".

NO >> GO TO 3.

3.CHECK TIRE PRESSURE SIGNAL

With CONSULT

1.  Adjust tire pressure for all wheels to the specified value. Refer to WT-65, "Tire Air Pressure".
2.  Select “AIR PRESSURE MONITOR” from “BCM” Data Monitor.
3.  Check that the air pressures match the specified value.

Is the inspection result normal? YES >> Inspection End.

NO >> Repair or replace malfunctioning components.