Nissan Rogue Owners Manual: Changing engine oil filter

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Engine oil / Changing engine oil filter

> Changing engine oil filter

Park the vehicle on a level surface and apply the parking brake.
Turn the engine off.
Place a large drain pan under the oil filter B .
Remove pins C from the right engine protector located inside right wheel well, remove protector. Remove oil filter B with an oil filter wrench by turning it counterclockwise.
Then remove the oil filter by turning it by hand.

CAUTION

Be careful not to burn yourself. The engine oil may be hot.

Wipe the engine oil filter sealing surface with a clean rag.

CAUTION

Be sure to remove any old gasket material remaining on the sealing surface of the engine. Failure to do so could lead to an oil leak and engine damage.
The dipstick must be inserted in place to prevent oil spillage from the dipstick hole when filling the engine with oil.

Coat the gasket on the new filter with clean engine oil.
Screw on the oil filter until a slight resistance is felt, then tighten an additional 2/3 turn.
Start the engine and check for leakage around the oil filter. Correct as required.
Turn the engine off and wait more than 10 minutes. Check the oil level. Add engine oil if necessary.

Changing engine oil

Changing engine oil Park the vehicle on a level surface and apply the parking brake. Start the engine and let it idle until it reaches operating temperature, then turn it off. & ...

Continuously Variable Transmission (CVT) fluid

CAUTION NISSAN recommends using Genuine NISSAN CVT Fluid NS-3 ONLY in NISSAN CVTs. Do not mix with other fluids. Do not use Automatic transmission fluid (ATF ...

Other materials:

U1111 lost communication (chassis control module)
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition U1111 LOST COMM (CHASSIS CONT MDUL) (Lost Communication With Chassis Control Module) When the ignition switch is ON, TCM is unable to receive the CA ...

Moonroof does not operate properly
Diagnosis Procedure 1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT Check BCM power supply and ground circuit. Refer to BCS-68, "Diagnosis Procedure" (with Intelligent Key System), BCS-128, "Diagnosis Procedure" (without Intelligent Key System) Is the inspection result norm ...

Passenger compartment
CAUTIONNever use a fuse of a higher or lower amperage rating than specified on the fuse box cover. This could damage the electrical system or cause a fire. If any electrical equipment does not operate, check for an open fuse. NOTE: The fuse box is located on the driver ...