Nissan Rogue manuals

Nissan Rogue Service Manual: EPS warning lamp

Component Function Check

1.CHECK THE ILLUMINATION OF THE EPS WARNING LAMP

Check that the EPS warning lamp turns ON when ignition switch turns ON. Then, EPS warning lamp turns OFF after the engine is started.

Is the inspection result normal? YES >> Inspection End.

NO >> Perform trouble diagnosis. Refer to STC-28, "Diagnosis Procedure".

Diagnosis Procedure

1.PERFORM SELF-DIAGNOSIS

With CONSULT

  1.  Turn the ignition switch OFF to ON.
  2.  Perform “EPS” self-diagnosis.

Is any DTC detected? YES >> Check the DTC. Refer to STC-13, "DTC Index".

NO >> GO TO 2.

2.CHECK EPS WARNING LAMP SIGNAL

With CONSULT

  1.  Turn the ignition switch ON.

    CAUTION: Never start the engine.

  2.  Select “DATA MONITOR” of “EPS” and select “WARNING LAMP”.
  3.  Check that the EPS warning lamp is turned ON.
  4. Start the engine.

    CAUTION: Never drive the vehicle.

  5.  Check that the EPS warning lamp is turned OFF.

Is the inspection result normal? YES >> Perform the trouble diagnosis for combination meter power supply circuit. Refer to WCS-39, "COMBINATION METER : Diagnosis Procedure".

NO >> EPS control unit is malfunctioning. Replace steering column assembly. Refer to STC-36, "Removal and Installation".

U1000 CAN COMM circuit
Description CAN (Controller Area Network) is a serial communication line for real time application. It is an on-vehicle multiplex communication line with high data communication speed and excellen ...

Symptom diagnosis
...

Other materials:

Removal and installation
NATS ANTENNA AMP. Exploded View Instrument finisher B Push button ignition switch NATS antenna amp. Pawl Removal and Installation REMOVAL  Remove the instrument finisher B. Refer to IP-16, "INSTRUMENT FINISHER B : Removal and Installation".  Release ...

Removal and installation
STARTER MOTOR Exploded View REMOVAL Transaxle assembly Starter motor Lower bolt  Upper bolt Removal and Installation REMOVAL  Remove battery tray. Refer to PG-77, "Removal and Installation".  Remove terminal B nut and terminal B harness.  R ...

Luggage trim
Exploded View WITH THIRD ROW SEAT Tonneau cover (if equipped)  Strap (LH/RH)  Luggage floor finisher (RH)  Luggage floor center finisher Luggage floor finisher (LH)  Luggage side lower finisher (LH) Luggage side upper finisher (LH) Hooks (LH/RH) Lug ...

© 2014-2019 Copyright www.nirogue.com