Nissan Rogue Owners Manual: Lights

Nissan Rogue Owners Manual / Maintenance and do-it-yourself / Lights

Headlights

Replacing the halogen headlight bulb (if so equipped)

The headlight is a semi-sealed beam type which uses a replaceable headlight (halogen) bulb. Because the headlight assembly must be removed from the vehicle for bulb replacement, see your NISSAN dealer.

CAUTION

Aiming is not necessary after replacing the bulb. When aiming adjustment is necessary, contact a NISSAN dealer.
Do not leave the headlight assembly open without a bulb installed for a long period of time. Dust, moisture, smoke, etc. entering the headlight body may affect bulb performance. Remove the bulb from the headlight assembly just before a replacement bulb is installed.
Only touch the base when handling the bulb. Never touch the glass envelope.
Touching the glass could significantly affect bulb life and/or headlight performance.
High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.

Fog may temporarily form inside the lens of the exterior lights in the rain or in a car wash. A temperature difference between the inside and the outside of the lens causes the fog. This is not a malfunction. If large drops of water collect inside the lens, contact a NISSAN dealer.

Replacing the LED headlight bulb (if so equipped)

If LED headlight bulb replacement is required, see your NISSAN dealer.

Fog lights (if so equipped)

If replacement is required, see your NISSAN dealer.

CAUTION

High pressure halogen gas is sealed inside the halogen bulb. The bulb may break if the glass envelope is scratched or the bulb is dropped.
When handling the bulb, do not touch the glass envelope.
Use the same number and wattage as originally installed as shown in the chart.
Do not leave the bulb out of the fog light for a long period of time as dust, moisture and smoke may enter the fog light body and affect the performance of the fog light.

Exterior and interior lights

NISSAN Intelligent Key® (if so equipped)

Replace the battery in the Intelligent Key as follows: Remove the mechanical key from the Intelligent Key. Insert a small screwdriver A into the slit B of the corner and twist it to se ...

Exterior and interior lights

Item Wattage (W) Bulb No. Headlight assembly* High 65 H9 Low 55 H11 Park 5 W5W Turn 28/8 ...

Other materials:

B0001, B0002 driver airbag module
DTC Logic DTC DETECTION LOGIC CONSULT name DTC DTC detecting condition Repair order DRIVER AIRBAG MODULE CIRCUIT [OPEN] B0001 Driver air bag module circuit (DR1) is open (including the spiral cable). Refer to SRC-47, "Diagnosis Proced ...

Drinking alcohol/drugs and driving
WARNINGNever drive under the influence of alcohol or drugs. Alcohol in the bloodstream reduces coordination, delays reaction time and impairs judgement. Driving after drinking alcohol increases the likelihood of being involved in an accident injuring yourself and others. Add ...

Uniform tire quality grading
DOT (Department of Transportation) Quality Grades: All passenger car tires must conform to federal safety requirements in addition to these grades. Quality grades can be found where applicable on the tire sidewall between tread shoulder and maximum section width. For example: Treadwear 200 ...