Nissan Rogue Service Manual: Mixture ratio self-learning value clear

Nissan Rogue Service Manual / Engine / Engine Control System / Basic inspection / Mixture ratio self-learning value clear

Description

This describes how to erase the mixture ratio self-learning value. For the actual procedure, follow the instructions in “Diagnosis Procedure”.

Work Procedure

1.START

With CONSULT

Start engine and warm it up to normal operating temperature.
Select “SELF-LEARNING CONT” in “WORK SUPPORT” mode of “ENGINE” using CONSULT.
Clear mixture ratio self-learning value by touching “CLEAR”.

With GST

Start engine and warm it up to normal operating temperature.
Turn ignition switch OFF.
Disconnect mass air flow sensor harness connector.
Restart engine and let it idle for at least 5 seconds.
Stop engine and reconnect mass air flow sensor harness connector.
Select Service $03 with GST. Make sure DTC P0102 is detected.
Select Service $04 with GST to erase the DTC P0102.

>> END

Idle air volume learning

Description Idle Air Volume Learning is a function of ECM to learn the idle air volume that keeps each engine idle speed within the specific range. It must be performed under any of the following ...

Fuel pressure

Work Procedure FUEL PRESSURE RELEASE 1.FUEL PRESSURE RELEASE With CONSULT Turn ignition switch ON. Perform “FUEL PRESSURE RELEASE” in “WORK SUPPORT” mode of “ENGINE” ...

Other materials:

Preparation
Special Service Tools The actual shape of the tools may differ from those illustrated here. Tool number (TechMate No.) Tool name Description — (165-GR8-1200KIT-NI) Multitasking battery and electrical diagnostic station Testing batteries, start ...

Rear power window switch
Description Rear power window motor will be operated if rear power window switch is operated. Component Function Check 1. CHECK REAR POWER WINDOW SWITCH FUNCTION Check rear power window motor operation with rear power window switch. Is the inspection result normal? YES >> Rear power ...

Basic inspection
DIAGNOSIS AND REPAIR WORKFLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1. GET INFORMATION FOR SYMPTOM Get the detailed information from the customer about the symptom (the condition and the environment when the incident/malfunction occurred). >> GO TO 2. 2. CHECK DTC ...