Nissan Rogue Service Manual: P0863 TCM communication

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Dtc/circuit diagnosis / P0863 TCM communication

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0863	CONTROL UNIT (CAN) (TCM Communication Circuit)	An error is detected at the initial CAN diagnosis of TCM.

POSSIBLE CAUSE

TCM

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine.
Check the DTC.

Is “P0863” detected? YES >> Go to TM-154, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.REPLACE TCM

Replace TCM. Refer to TM-202, "Removal and Installation".

>> WORK END

P084d transmission fluid pressure SEN/SW H

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P084D FLUID PRESS SEN/SW H (Transmission Fluid Pressur ...

P0890 TCM

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0890 TCM (Transmission Control Module Power Relay ...

Other materials:

ECU diagnosis information
DIAGNOSIS SENSOR UNIT DTC Index DIAGNOSTIC CODE CHART NOTE: Follow the procedures in numerical order when repairing malfunctioning parts. Confirm whether malfunction is eliminated using air bag warning lamp or CONSULT each time repair is finished. If malfunction is still observed, proceed ...

Power window retained power operation does not operate properly
Diagnosis Procedure 1.CHECK DOOR SWITCH Check door switch. Refer to DLK-149, "Component Function Check" (with Intelligent Key system) or DLK-319, "Component Function Check" (without Intelligent Key system). Is the inspection result normal? YES >> GO TO 2. NO ...

Fuel level sensor signal circuit
Component Function Check 1.COMBINATION METER INPUT SIGNAL Select "METER/M&A" on "CONSULT". Using "FUEL METER" of "Data Monitor", compare the value of "Data Monitor" with fuel gauge pointer of combination meter. Does ...