Nissan Rogue Service Manual: Parking brake shoe
Inspection and Adjustment
- Adjust parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions:
- Drive forward
- Vehicle speed: Approx. 40 km/h (25 MPH) set (constant and forward)
- Parking brake operating force: Approx. 160 +30.0 N (16.3 +3.1 kg-f, 36.0 +6.7 lb-f)
- Time: Approx. 10 +5.0 seconds.
CAUTION: To prevent lining from getting too hot, allow a cool off period of approximately 5 minutes after every break-in operation.
- After the break-in procedure, check parking pedal stroke of parking brake.
CAUTION: If it is out of the specification, adjust again. Refer to PB-4, "Inspection and Adjustment".
ADJUSTMENT AFTER INSTALLATION
- Adjust the parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment".
- Rotate the disc brake rotor with the parking brake pedal released
and check that there is no drag.
CAUTION: If any drag is found, verify the parking brake components are installed and adjusted correctly.
Parking brake system
Inspection and Adjustment
INSPECTION
Pedal Stroke
Operate the parking brake pedal with a force of 196 N (20.0 kg-f,
44.1 lb-f). Check that the pedal stroke is
within the specified num ...
Other materials:
Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW
Work Flow
OVERALL SEQUENCE
DETAILED FLOW
1.OBTAIN INFORMATION ABOUT SYMPTOM
Interview the customer to obtain as much information as possible about the
conditions and environment under
which the malfunction occurred.
>> GO TO 2.
2.CHECK SYMPTOM
...
Power window and door lock/unlock switch RH
Removal and Installation
REMOVAL
Remove the front door pull handle bracket (RH). Refer to INT-15,
"Removal and Installation".
Release pawls using a suitable tool (A) and remove front door
power window and door lock/unlock switch finisher (RH) (1).
: Pawl
D ...
Idle air volume learning
Description
Idle Air Volume Learning is a function of ECM to learn the idle air volume
that keeps each engine idle speed
within the specific range. It must be performed under any of the following
conditions:
Each time electric throttle control actuator or ECM is replaced.
Idle spee ...