Nissan Rogue Service Manual: Periodic maintenance
FRONT WHEEL HUB AND KNUCKLE
Inspection
- Move the wheel hub and bearing in an axial direction by hand to verify that looseness of wheel hub and bearing exists. If any looseness exists, replace the wheel hub and bearing.
Axial end play : Refer to FAX-32, "Wheel Bearing".
- Rotate wheel hub and bearing to verify if unusual noises or other irregular conditions exist. If any irregular conditions exist, replace the wheel hub and bearing.
FRONT DRIVE SHAFT
Inspection
Check the following items and replace parts as necessary:
- Check drive shaft mounting point and joint for looseness and other damage.
- Check boot for cracks and other damage.
CAUTION: Replace entire drive shaft when noise or vibration occurs from drive shaft.
Symptom diagnosis
NOISE, VIBRATION AND HARSHNESS (NVH) TROUBLESHOO
NVH Troubleshooting Chart
Use chart below to find the cause of the symptom. If necessary, repair or
replace these parts.
×: Applicable ...
Removal and installation
FRONT WHEEL HUB
Exploded View
Disc brake rotor
Nut retainer
Cotter pin
Wheel stud
Steering knuckle
Splash guard
Wheel hub and bearing
Wheel hub lock n ...
Other materials:
System
FRONT WIPER AND WASHER SYSTEM
FRONT WIPER AND WASHER SYSTEM : System Diagram
FRONT WIPER AND WASHER SYSTEM : System Description
OUTLINE
FRONT WIPER CONTROL (BASIC)
BCM detects the combination switch position by the combination
switch reading function.
BCM transmits the f ...
NISSAN vehicle immobilizer system
The NISSAN Vehicle Immobilizer system will not
allow the engine to start without the use of the
registered key.
If the engine fails to start using a registered key
(for example, when interference is caused by
another registered key, an automated toll road
device or automatic payment device o ...
Precautions on child restraints
WARNING
Failure to follow the warnings and instructions
for proper use and installation
of child restraints could result in
serious injury or death of a child or
other passengers in a sudden stop or
collision:
The child restraint must be ...