Nissan Rogue Service Manual: Rear wiper motor circuit

Component Function Check

1. CHECK REAR WIPER ON OPERATION

CONSULT ACTIVE TEST

1.  Select "RR WIPER" of BCM active test item.
2.  While operating the test item, check rear wiper operation.

ON : Rear wiper ON operation
OFF : Stop the rear wiper.

Is rear wiper operation normal? YES >> Rear wiper motor circuit is normal.

NO >> Refer to WW-47, "Diagnosis Procedure".

Diagnosis Procedure

Regarding Wiring Diagram information, refer to WW-28, "Wiring Diagram".

1. CHECK REAR WIPER MOTOR OUTPUT VOLTAGE

CONSULT ACTIVE TEST

1.  Turn the ignition switch OFF.
2.  Disconnect rear wiper motor.
3.  Turn the ignition switch ON.
4.  Select RR WIPER of BCM active test item.
5.  While operating the test item, check voltage between BCM harness connector and ground.

Is the inspection result normal? YES >> GO TO 2.

NO >> GO TO 3.

2. CHECK REAR WIPER MOTOR GROUND CIRCUIT

1.  Turn the ignition switch OFF.
2.  Check continuity between rear wiper motor harness connector and ground.

Is the inspection result normal? YES >> Replace rear wiper motor. Refer to WW-71, "Removal and Installation".

NO >> Repair or replace harness.

3. CHECK REAR WIPER MOTOR OPEN CIRCUIT

Check continuity between BCM harness connector and rear wiper motor harness connector.

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness.

4. CHECK REAR WIPER MOTOR SHORT CIRCUIT

Check continuity between BCM harness connector and ground.

Is the inspection result normal? YES >> Repair or replace harness.

NO >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).