Nissan Rogue Service Manual: The key warning does not sound (without intelligent key)

Nissan Rogue Service Manual / Driver information & multimedia / Warning Chime System / Symptom diagnosis / The key warning does not sound (without intelligent key)

Description

The key warning chime does not sound, when all of the following conditions are fulfilled:

Key inserted into the key cylinder (key switch signal ON).
Ignition switch is in OFF position (ignition switch signal OFF).
Driver side door is open (front door switch LH ON)

Diagnosis Procedure

1.CHECK BCM INPUT SIGNAL

Connect CONSULT.
Select the "DATA MONITOR" of "BCM (BUZZER)" and check the "KEY ON SW" monitor value.

Check bcm input signal

Is the inspection result normal? YES >> Replace the BCM. Refer to BCS-135, "Removal and Installation".

NO >> GO TO 2.

2.CHECK KEY SWITCH SIGNAL CIRCUIT

Check the key switch signal circuit. Refer to WCS-47, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 3.

NO >> Repair or replace harness or connector.

3.CHECK KEY SWITCH

Check the key switch. Refer to WCS-48, "Component Inspection".

Is the inspection result normal? YES >> Replace the BCM. Refer to BCS-135, "Removal and Installation".

NO >> Replace key switch.

The light reminder warning does not sound

Description Light reminder warning does not sound even though headlamp is illuminated. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL Select the "Data Monitor" for the " ...

Audio, Visual & Navigation System

...

Other materials:

P0139 HO2S2
DTC Description DTC DETECTION LOGIC The heated oxygen sensor 2 has a much longer switching time between rich and lean than the air fuel ratio (A/F) sensor 1. The oxygen storage capacity of the three way catalyst 1 causes the longer switching time. To judge the malfunctions of heated oxygen sens ...

Tire chains
Use of tire chains may be prohibited according to location. Check the local laws before installing tire chains. When installing tire chains, make sure they are the proper size for the tires on your vehicle and are installed according to the chain manufacturer’s suggestions. Use only SAE clas ...

Steering angle sensor
Exploded View Combination switch Steering angle sensor Spiral cable Removal and Installation Removal and Installation Remove the spiral cable. Refer to SR-15, "Exploded View". Remove screws (A) and then remove steering angle sensor (1). INSTALLATI ...