Nissan Rogue Service Manual: The seat belt reminder warning continues sounding, or does not sound

Nissan Rogue Service Manual / Driver information & multimedia / Warning Chime System / Symptom diagnosis / The seat belt reminder warning continues sounding, or does not sound

Description

Seat belt warning does not sound even though driver seat belt is not fastened.
Seat belt warning sounds even though driver seat belt is fastened.

Diagnosis Procedure

1.CHECK WARNING CHIME OPERATION

Select "BUZZER" of "BCM" on "CONSULT".
Perform "SEAT BELT WARN TEST" of "ACTIVE TEST".

Check warning chime operation

Is the inspection result normal? YES >> GO TO 2.

NO >> Replace combination meter. Refer to MWI-82, "Removal and Installation".

2.CHECK COMBINATION METER INPUT SIGNAL

Check the combination meter input signal. Refer to WCS-43, "Component Function Check".

Is the inspection result normal? YES >> Replace BCM. Refer to BCS-75, "Removal and Installation" (with Intelligent Key system) or BCS- 135, "Removal and Installation" (without Intelligent Key system).

NO >> GO TO 3.

3.CHECK SEAT BELT BUCKLE SWITCH LH CIRCUIT

Check the seat belt buckle switch LH circuit. Refer to WCS-43, "Diagnosis Procedure".

Is the inspection result normal? YES >> GO TO 4.

NO >> Repair or replace harness or connector.

4.CHECK SEAT BELT BUCKLE SWITCH LH

Check the seat belt buckle switch LH. Refer to WCS-44, "Component Inspection".

Is the inspection result normal? YES >> Replace the combination meter. Refer to MWI-82, "Removal and Installation".

NO >> Replace the seat belt buckle switch LH. Refer to SB-11, "FRONT SEAT BELT BUCKLE : Removal and Installation".

The parking brake release warning continues sounding, or does not sound

Description The parking brake warning buzzer sounds continuously during vehicle travel though the parking brake is released. The parking brake warning buzzer does not sound at all eve ...

The light reminder warning does not sound

Description Light reminder warning does not sound even though headlamp is illuminated. Diagnosis Procedure 1.CHECK COMBINATION METER INPUT SIGNAL Select the "Data Monitor" for the " ...

Other materials:

Power switch illumination circuit
Description Provides the power supply and the ground to control the power switch illumination. Component Function Check 1.CHECK POWER SWITCH ILLUMINATION OPERATION CONSULT ACTIVE TEST Turn the power switch ON. Select “ENGINE SW ILLUMI” of “BCM” active test item. &n ...

P0125 ECT sensor
DTC Description DTC DETECTION LOGIC DTC No. CONSULT screen terms (Trouble diagnosis content) DTC detecting condition P0125 ECT SENSOR (Insufficient coolant temperature for closed loop fuel control) Voltage sent to ECM from the sensor is not practical, ...

Front disc brake
BRAKE PAD BRAKE PAD : Inspection Check brake pad wear thickness from an inspection hole (A) on cylinder body. Check using a scale if necessary. Wear thickness : Refer to BR-55, "Front Disc Brake". DISC BRAKE ROTOR DISC BRAKE ROTOR : Inspection APPEARANCE Check surface of disc b ...