Nissan Rogue manuals

Nissan Rogue Owners Manual: Towing recommended by NISSAN

All-Wheel Drive (AWD) models
All-Wheel Drive (AWD) models

NISSAN recommends that towing dollies be used when towing your vehicle or the vehicle be placed on a flatbed truck as illustrated.

CAUTION

DO NOT tow AWD models with any of the wheels on the ground as this may cause serious and expensive damage to the powertrain.

Front-Wheel Drive models
Front-Wheel Drive models

NISSAN recommends that your vehicle be towed with the driving wheels (front) off the ground or place the vehicle on a flatbed truck as illustrated.

WARNING
  •  Never tow your vehicle with the front wheels on the ground or 4 wheels on the ground (forward or backward), as this may cause serious and expensive damage to the transmission. If it is necessary to tow the vehicle with the rear wheels raised always use towing dollies under the front wheels.
  •  When towing with the rear wheels on the ground or on towing dollies, place the ignition switch in the ON position, and secure the steering wheel in the straight-ahead position with a rope or similar device.
Towing your vehicle
When towing your vehicle, all jurisdictional and local regulations for towing must be followed. Incorrect towing equipment could damage your vehicle. Towing instructions are available from a NIS ...

Vehicle recovery (freeing a stuck vehicle)
Pulling a stuck vehicle WARNINGTo avoid vehicle damage, serious personal injury or death when recovering a stuck vehicle:  Contact a professional towing service to recov ...

Other materials:

Body construction
Body Construction Outer body side Outer front pillar reinforcement Upper inner front pillar  Rear hoodledge reinforcement Side dash Inner front pillar reinforcement Lower front pillar hinge brace Upper hinge plate Weld nut Upper dash  Upper steering membe ...

Parking brake switch signal circuit
Component Function Check 1.CHECK PARKING BRAKE SWITCH OPERATION Check that brake warning lamp in combination meter turns ON/OFF when parking brake is actuated. Is the inspection result normal? YES >> Inspection End. NO >> Proceed to diagnosis procedure. Refer to WCS-45, " ...

Basic inspection
DIAGNOSIS AND REPAIR WORK FLOW Work Flow OVERALL SEQUENCE DETAILED FLOW 1.OBTAIN INFORMATION ABOUT SYMPTOM Interview the customer to obtain as much information as possible about the conditions and environment under which the malfunction occurred. >> GO TO 2. 2.CHECK SYMPTOM ...

В© 2014-2019 Copyright www.nirogue.com