Nissan Rogue Service Manual: Basic inspection

CONFIGURATION (CAN GATEWAY)

Work Procedure

1.WRITING MODE SELECTION

CONSULT Configuration

Select “Re/programming, Configuration” of CAN gateway.

When writing saved data>>GO TO 2.

When writing manually>>GO TO 3.

2.PERFORM “AFTER REPLACE ECU” OF “READ / WRITE CONFIGURATION”

CONSULT Configuration

Perform “After Replace ECU” of “Read / Write Configuration”.

>> GO TO 4.

3.PERFORM “MANUAL CONFIGURATION”

CONSULT Configuration

1.  Select “Manual Configuration”.
2.  Touch “Next”.
3.  Touch “OK”.
4. Check that the configuration has been successfully written and touch “End”.

>> GO TO 4.

4.CHECK ALL ECU SELF-DIAGNOSIS RESULTS

1. Erase all ECU self-diagnosis results using CONSULT.
2.  Turn the ignition switch OFF.
3.  Turn the ignition switch ON and wait for 2 seconds or more.
4.  Check that all ECU self-diagnosis results have no DTC (e.g. U1000 and U1001) of CAN communication.

>> WORK END