Nissan Rogue Service Manual: Electrical & power control
- Power Outlet
- Precaution
- System description
- Wiring diagram
- Removal and installation
- Service data and specifications (SDS)
- Body Control System
- LAN System
- CAN fundamental
- CAN
- CAN gateway
- CAN system (type 1)
- CAN system (type 2)
- CAN system (type 3)
- CAN system (type 4)
- CAN system (type 5)
- CAN system (type 6)
- CAN system (type 7)
- CAN system (type 8)
- Power Control System
- Charging System
- Precaution
- Preparation
- System description
- Wiring diagram
- Basic inspection
- DTC/circuit diagnosis
- Symptom diagnosis
- Removal and installation
- Service data and specifications (SDS)
- Power Supply, Ground & Circuit Elements
Removal and installation
HORN
Exploded View
Horn (LOW)
Horn (HIGH)
Removal and Installation
REMOVAL
Horn (LOW)
Remove the front grille. Refer to EXT-23, "Removal and
Installation".
&n ...
Power Outlet
...
Other materials:
Adjustment of steering angle sensor neutral position
Description
Refer to the table below to determine if adjustment of steering angle sensor
neutral position is required.
Work Procedure
ADJUSTMENT OF STEERING ANGLE SENSOR NEUTRAL POSITION
CAUTION:
To adjust neutral position of steering angle sensor, make sure to use CONSULT.
(Adjustment ...
DTC/circuit diagnosis
B2600-46 CONFIG ERROR
DTC Description
DTC DETECTION LOGIC
DTC
Trouble diagnosis
(Trouble diagnosis contents)
Detecting condition
B2600-46
CONFIG ERROR
(Configuration error)
When errors are detected in the configuration data stored in the BCM
(CAN
...
Periodic maintenance
IDLE SPEED
Inspection
1.CHECK IDLE SPEED
With CONSULT
Check idle speed in “DATA MONITOR” mode of “ENGINE” using CONSULT.
With GST
Check idle speed with Service $01 of GST.
>> INSPECTION END
IGNITION TIMING
Inspection
1.CHECK IGNITION TIMING
Attach timing light (A) to th ...