Map lights
Push the button to turn the map lights on. To turn them off, press the button again.
CAUTION Do not use for extended periods of time with the engine stopped. This could result in a discharged battery. |
Personal Lights (if so equipped)
Rear personal lights
To turn the rear personal lights on, press the switch. To turn them off, press the switch again.
Cargo light
Cargo light
The cargo light on the overhead trim has a threeposition switch. To operate, push the switch to the desired position.
CAUTION Do not use for extended periods of time with the engine stopped. This could result in a discharged battery. |
Front passenger air bag module
Exploded View
Front passenger air bag module
Steering member
Removal and Installation
WARNING:
Before servicing the SRS, turn ignition switch OFF, disconnect
both battery terminals then wait at
least three minutes.
Always work from the side of air bag module. Do ...
U1000 CAN COMM circuit
Description
CAN (Controller Area Network) is a serial communication system for real time
application. It is an on-vehicle
multiplex communication system with high data communication speed and excellent
error detection ability.
Many electronic control units are equipped into vehicles, and ea ...
Sensor maintenance
Sensor maintenance
The distance sensor for the FCW system A is
located behind the front bumper.
To keep the FCW system operating properly, be
sure to observe the following:
Always keep the sensor area of the front
bumper clean.
Do not strike or damage the areas around
...