Nissan Rogue Service Manual: P0779 pressure control solenoid B

Nissan Rogue Service Manual / Transmission & driveline / Transaxle & Transmission / Dtc/circuit diagnosis / P0779 pressure control solenoid B

DTC Description

DTC DETECTION LOGIC

DTC	CONSULT screen terms (Trouble diagnosis content)	DTC detection condition
P0779	Pressure control solenoid B Inte	When all of the following conditions are satisfied and this state is maintained for 0.2 seconds: TCM power supply voltage: More than 11 V P0778 is not detected TCM judges that solenoid valve circuit is open or shorted to power supply.

POSSIBLE CAUSE

Harness or connector (Secondary pressure solenoid valve circuit open or shorted to power supply)
Secondary pressure solenoid valve

FAIL-SAFE

Selector shock is large
Start is slow
Acceleration is slow
Lock-up is not performed

DTC CONFIRMATION PROCEDURE

1.PREPARATION BEFORE WORK

If another "DTC CONFIRMATION PROCEDURE" occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

Start the engine.
Drive the vehicle.
Maintain the following conditions for 5 seconds or more.

Selector lever : “D” position
Vehicle speed : 40 km/h (25 MPH) or more

Stop the vehicle.
Check the first trip DTC.

Is “P0779” detected? YES >> Go to TM-143, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.CHECK CIRCUIT BETWEEN TCM AND CVT UNIT

Turn ignition switch OFF.
Disconnect TCM connector and CVT unit connector.
Check continuity between TCM harness connector terminal and CVT unit harness connector terminal.

Check circuit between TCM and CVT unit

Is the inspection result normal?

YES >> GO TO 2.

NO >> Repair or replace damaged parts.

2.CHECK CIRCUIT BETWEEN CVT UNIT AND GROUND

Check continuity between CVT unit harness connector terminal and ground.

Check circuit between CVT unit and ground

Is the inspection result normal? YES >> INSPECTION END

NO >> There is malfunction of secondary pressure solenoid valve. Replace transaxle assembly. Refer to TM-220, "Removal and Installation".

P0778 pressure control solenoid B

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0778 PC SOLENOID B (Pressure Control Solenoid “B” ...

P0841 transmission fluid pressure SEN/SW A

DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressur ...

Other materials:

FCW system operation
Forward Collision Warning light The FCW system is active at speeds of approximately 10 MPH (15 km/h) and above, when the system turns on. When FCW is turned on, FCW Indicator (white) will turn on. FCW system is activated using the settings menu on the information display. For additional ...

Rapid air pressure loss
Rapid air pressure loss or a “blow-out” can occur if the tire is punctured or is damaged due to hitting a curb or pothole. Rapid air pressure loss can also be caused by driving on under-inflated tires. Rapid air pressure loss can affect the handling and stability of the vehicle, especial ...

Parking brake shoe
Inspection and Adjustment Adjust parking brake pedal stroke. Refer to PB-4, "Inspection and Adjustment". Perform parking brake break-in (drag on) operation by driving vehicle under the following conditions: Drive forward Vehicle speed: Approx. 40 km/h (25 MPH) set ...