Nissan Rogue manuals

Nissan Rogue Service Manual: P0841 transmission fluid pressure SEN/SW A

DTC Description

DTC DETECTION LOGIC

DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition
P0841 FLUID PRESS SEN/SW A (Transmission Fluid Pressure Sensor/Switch “A” Circuit Range/Performance) When all of the following conditions are satisfied and this state is maintained for 5 seconds:
  •  TCM power supply voltage: More than 11 V
  •  DTC other than the applicable DTC is not detected.
  •  Primary pulley speed: 300 rpm or more
  •  Secondary pulley speed: 250 rpm or more
  •  Target speed for shifting: Less than 0.1 seconds
  •  Primary pulley pressure is outside the specified value.

POSSIBLE CAUSE

FAIL-SAFE

Not changed from normal driving

DTC CONFIRMATION PROCEDURE

CAUTION: Always drive vehicle at a safe speed.

1.PREPARATION BEFORE WORK

If another “DTC CONFIRMATION PROCEDURE” occurs just before, turn ignition switch OFF and wait for at least 10 seconds, then perform the next test.

>> GO TO 2.

2.CHECK DTC DETECTION

  1.  Start the engine.
  2.  Drive the vehicle.
  3.  Maintain the following condition for 10 seconds or more.

Selector lever : “D” position
Vehicle speed : Constant speed of 40 km/h (25 MPH)

CAUTION: Also keep the accelerator pedal position constant.

  1.  Stop the vehicle.
  2.  Check the first trip DTC.

Is “P0841” detected? YES >> Go to TM-145, "Diagnosis Procedure".

NO-1 >> To check malfunction symptom before repair: Refer to GI-41, "Intermittent Incident".

NO-2 >> Confirmation after repair: INSPECTION END

Diagnosis Procedure

1.REPLACE TRANSAXLE ASSEMBLY

Replace transaxle assembly. Refer to TM-220, "Removal and Installation".

>> WORK END

P0779 pressure control solenoid B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0779 Pressure control solenoid B Inte When all of the ...

P0847 transmission fluid pressure SEN/SW B
DTC Description DTC DETECTION LOGIC DTC CONSULT screen terms (Trouble diagnosis content) DTC detection condition P0847 FLUID PRESS SEN/SW B (Transmission Fluid Pressur ...

Other materials:

Mudguard
Exploded View Front mud guard  Rear mud guard Removal and Installation FRONT MUD GUARD Removal Remove front mud guard screws and remove front mud guard. Installation Installation is in the reverse order of removal. REAR MUD GUARD Removal Remove rear mud guard screws and re ...

How to select piston and bearing
DESCRIPTION Selection points Selection parts Selection items Selection methods Between cylinder block to crankshaft Main bearing Main bearing grade (bearing thickness) Determined by match of cylinder block bearing housing grade (inner diameter of housin ...

Child safety
WARNINGDo not allow children to play with the seat belts. Most seating positions are equipped with Automatic Locking Retractor (ALR) mode seat belts. If the seat belt becomes wrapped around a child’s neck with the ALR mode activated, the child can be seriously injured or k ...

© 2014-2019 Copyright www.nirogue.com