Nissan Rogue Service Manual: P1574 ASCD vehicle speed sensor

Description

The ECM receives two vehicle speed sensor signals via CAN communication line. One is sent from combination meter, and the other is from TCM (Transmission control module). The ECM uses these signals for ASCD control. Refer to EC-47, "AUTOMATIC SPEED CONTROL DEVICE (ASCD) : System Description" for ASCD functions.

DTC Description

DTC DETECTION LOGIC

POSSIBLE CAUSE

•  Harness or connectors (CAN communication line is open or shorted.)
•  ABS actuator and electric unit (control unit)
•  TCM
•  ECM

FAIL-SAFE

Not applicable

DTC CONFIRMATION PROCEDURE

1.CHECK DTC PRIORITY

If DTC P1574 is displayed with DTC U1001, P0500, P0603, P0604, P0605, P0606, P0607, P060A or P060B, first perform the trouble diagnosis for DTC U1001, P0500, P0603, P0604, P0605, P0606, P0607, P060A or P060B.

Is applicable DTC detected? YES >> Perform diagnosis of applicable. Refer to EC-93, "DTC Index".

NO >> GO TO 2.

2.PRECONDITIONING

If DTC Confirmation Procedure has been previously conducted, always perform the following procedure before conducting the next test.

1.  Turn ignition switch OFF and wait at least 10 seconds.
2.  Turn ignition switch ON.
3.  Turn ignition switch OFF and wait at least 10 seconds.

>> GO TO 3.

3.PERFORM DTC CONFIRMATION PROCEDURE

1.  Start engine.
2.  Drive the vehicle at more than 40 km/h (25 MPH).

   CAUTION: Always drive vehicle at a safe speed.

   NOTE: This procedure may be conducted with the drive wheels lifted in the shop or by driving the vehicle.

   If a road test is expected to be easier, it is unnecessary to lift the vehicle.

3.  Check DTC.

Is DTC detected? YES >> Proceed to EC-415, "Diagnosis Procedure".

NO >> INSPECTION END

Diagnosis Procedure

1.CHECK DTC PRIORITY

If DTC P1574 is displayed with DTC U1001, P0500, P0603, P0604, P0605, P0606, P0607, P060A or P060B, first perform the trouble diagnosis for DTC U1001, P0500, P0603, P0604, P0605, P0606, P0607, P060A or P060B.

Is applicable DTC detected? YES >> Perform diagnosis of applicable. Refer to EC-93, "DTC Index".

NO >> GO TO 2.

2.CHECK DTC WITH TCM

Check DTC with TCM. Refer to TM-47, "CONSULT Function".

Is DTC detected? NO >> GO TO 3.

YES >> Perform trouble shooting relevant to DTC indicated.

3.CHECK DTC WITH “ABS ACTUATOR AND ELECTRIC UNIT (CONTROL UNIT)”

Check DTC with ABS actuator and electric unit (control unit). Refer to BRC-44, "CONSULT Function".

Is DTC detected? NO >> INSPECTION END

YES >> Perform trouble shooting relevant to DTC indicated.