Nissan Rogue Service Manual: Seat belt buckle switch signal circuit
Description
Transmits a seat belt buckle switch signal to the combination meter.
Component Function Check
1. CHECK COMBINATION METER INPUT SIGNAL
- Ignition ON.
- Monitor seat belt warning lamp while fastening and unfastening the driver seat belt buckle.
Is the inspection result normal? YES >> Inspection End.
NO >> Refer to WCS-43, "Diagnosis Procedure".
Diagnosis Procedure
Regarding Wiring Diagram information, refer to WCS-29, "Wiring Diagram".
1. CHECK COMBINATION METER INPUT SIGNAL
- Turn ignition switch ON.
- Check voltage between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 2.
2. CHECK SEAT BELT BUCKLE SWITCH LH CIRCUIT
- Turn ignition switch OFF.
- Disconnect combination meter harness connector M76 and seat belt buckle switch LH harness connector B87.
- Check continuity between combination meter harness connector M76 terminal 28 and seat belt buckle switch LH harness connector B87 terminal 1.
- Check continuity between combination meter harness connector M76 terminal 28 and ground.
Is the inspection result normal? YES >> GO TO 3.
NO >> Repair or replace harness or connector.
3. CHECK SEAT BELT BUCKLE SWITCH LH GROUND CIRCUIT
Check continuity between seat belt buckle switch LH harness connector B87 terminal 2 and ground.
Is the inspection result normal? YES >> Inspection End.
NO >> Repair or replace harness or connector.
Component Inspection
1. CHECK SEAT BELT BUCKLE SWITCH
- Turn ignition switch OFF.
- Disconnect the seat belt buckle switch LH connector.
- Check continuity between the seat belt buckle switch LH terminals 1 and 2.
Is the inspection result normal? YES >> Inspection End.
NO >> Replace the seat belt buckle switch LH. Refer to SB-11, "FRONT SEAT BELT BUCKLE : Removal and Installation".
Meter buzzer circuit
Description
The buzzer for the warning chime system is installed in the combination
meter.
The combination meter sounds the buzzer based on the signals transmitted
from various units.
C ...
Parking brake switch signal circuit
Component Function Check
1.CHECK PARKING BRAKE SWITCH OPERATION
Check that brake warning lamp in combination meter turns ON/OFF when parking
brake is actuated.
Is the inspection result normal?
...
Other materials:
Rear washer nozzle and tube
Exploded View
Rear washer tube
Rear grommet
Clip
Removal and Installation - Rear Washer Nozzle
REMOVAL
Remove rear access panel. Refer to INT-38, "Exploded View".
Release pawls and remove rear washer nozzle (1).
: Pawl
INSTALLATION
Installation in the ...
P0444, P0445 EVAP canister purge volume control solenoid
DTC Description
DTC DETECTION LOGIC
DTC No.
CONSULT screen terms
(Trouble diagnosis content)
DTC detecting condition
P0444
PURG VOLUME CONT/V
(Evaporative emission system purge control
valve circuit open)
An excessively low voltage signal is sent to ECM through ...
Power supply and ground circuit
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM)
BCM (BODY CONTROL SYSTEM) (WITH INTELLIGENT KEY SYSTEM) : Diagnosis
Procedure
Regarding Wiring Diagram information, refer to BCS-50, "Wiring Diagram".
1. CHECK FUSE
Check that the following fuse is not blown.
Is the fuse blo ...