Nissan Rogue Service Manual: O/D off indicator lamp
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition switch turns ON.
Is the inspection results normal? YES >> INSPECTION END
NO >> Go to TM-181, "Diagnosis Procedure".
Diagnosis Procedure
1.CHECK DTC (TCM)
With CONSULT
- Turn ignition switch ON.
- Check “Self Diagnostic Results” in “TRANSMISSION”.
Is any DTC detected? YES >> Check DTC detected item. Refer to TM-63, "DTC Index".
NO >> GO TO 2.
2.CHECK DTC (COMBINATION METER)
With CONSULT
Check “Self Diagnostic Results” in “METER/M&A”.
Is any DTC detected? YES >> Check DTC detected item. Refer to MWI-30, "DTC Index".
NO >> GO TO 3.
3.CHECK COMBINATION METER INPUT/OUTPUT SIGNAL
With CONSULT
- Shift the selector lever to “D” position.
- Select “Data Monitor” in “METER/M&A”.
- Select “O/D OFF IND”.
- Check that “O/D OFF IND” turns ON/OFF when overdrive control switch is operated. Refer to MWI-24, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> GO TO 4.
4.CHECK TCM INPUT/OUTPUT SIGNAL
With CONSULT
- Select “Data Monitor” in “TRANSMISSION”.
- Select “SPORT MODE SW”.
- Check that “SPORT MODE SW” turns ON/OFF when overdrive control switch is operated. Refer to TM- 52, "Reference Value".
Is the inspection result normal? YES >> Replace combination meter. Refer to MWI-82, "Removal and Installation".
NO >> Check overdrive control switch circuit. Refer to TM-178, "Diagnosis Procedure".
Overdrive control switch
Component Function Check
1.CHECK O/D OFF INDICATOR LAMP FUNCTION
Check O/D OFF indicator lamp turns ON for approx. 2 seconds when ignition
switch turns ON.
Is the inspection results normal?
YE ...
Shift position indicator circuit
Component Parts Function Inspection
1.CHECK SHIFT POSITION INDICATOR
Start the engine.
Shift selector lever.
Check that the selector lever position and the shift position
...
Other materials:
Door mirror glass
Removal and Installation
REMOVAL
Release the metal clips and pawls that retain the door mirror
glass using a suitable tool, disconnect the harness connectors
(A) (if equipped) from the door mirror glass and remove.
Metal clip
: Pawl
INSTALLATION
Installation is in the rever ...
CAN system (type 1)
DTC/CIRCUIT DIAGNOSIS
MAIN LINE BETWEEN IPDM-E AND DLC CIRCUIT
Diagnosis Procedure
1.CHECK CONNECTOR
Turn the ignition switch OFF.
Disconnect the battery cable from the negative terminal.
Check the following terminals and connectors for damage, bend and
loose connecti ...
Low tire pressure warning lamp stays on
Low Tire Pressure Warning Lamp Stays On When Ignition Switch Is Turned On
1.CHECK BCM CONNECTORS
Turn ignition switch OFF.
Disconnect BCM connectors.
Check terminals for damage or loose connections.
Is the inspection result normal?
YES >> GO TO 2.
NO >> Repair ...